How can you turn on and off the air conditioner without a remote control

How to turn on the air conditioner automatically? Most often, this question arises in several cases:

• after a long downtime;
• if the remote control is broken (lost).

Let's figure it out in order with situations when the owners cannot independently figure out how to turn on the air conditioner.

How to turn on the air conditioner without a remote control

Sometimes the remote control disappears somewhere, the batteries run out or the remote control is broken. There is always a button to turn on the air conditioner! And it is located on the front of the indoor module under the curtains. The button for turning on the air conditioner is covered by a small cover made of the same plastic as the body. It must be carefully picked up and lifted.

The manual control panel is detected. The button can be illuminated. If the air conditioner is working properly, it glows with a red or green indicator. The switch is called operation or on \ off.

Press down on it and do not release your finger for a couple of seconds. You will hear a distinctive sound when the air conditioner is turned on. It means that the air conditioner is turning on. If you want to start heating, you need to quickly press the button again.

The air conditioner starts automatically. And you can make changes to it only with the help of the remote control.

How to turn on the air conditioner after a long period of inactivity

There is a certain air conditioner switching circuit after a long period of inactivity or transportation, you can perform the procedure yourself.

Step-by-step instructions for turning on the air conditioner in the cold after idle time:

• Make sure that the outside temperature is above zero;
• Turn off the air conditioner from the network;
• Check if the outdoor unit is dry, whether the radiator grill is intact;
• Check the condition of the filters in the indoor unit, clean them if necessary;
• Check the condition of the remote control batteries;
• Turn on the power supply, the sound when the air conditioner is turned on will notify about its start;
• If the air temperature in the room is higher than 20 degrees, set to the "cold" mode for the lowest temperature and the highest rotation speed of the fan blades;
• When really very cold air comes out of the case, leave it to work for a quarter of an hour, but for now check the operation of the curtain, the fan speeds;
• Turn off with the remote control. The air conditioner can now be used normally.

If after 10 minutes after the automatic switching on of the air conditioner there is no cold, weak blowing or noisy, you need to call the service department.

The circuit for switching on the air conditioner is very simple, even inexperienced users can cope with it. However, if during the check there are the slightest doubts about the operation of the device, immediately turn it off and call the masters.